! When you recall a presetstation, the tuner
may update the presetstation with a new fre-
quency from the station’s AF list. (This is only
available when using presetson the F1 or F2
bands.) No preset numberappears on the dis-
play if the RDS data forthe station received
differs from that for theoriginally stored sta-
tion.
! Sound may be temporarily interrupted by an-
other program during anAF frequency
search.
! AF can be turned onor off independently for
each FM band.
Using PI Seek
If the tuner can’t find a suitable station, or re-
ception status becomes bad, the unit will auto-
matically search for a different station with a
same programming. During the search,
PI SEEK is displayed and the output is muted.
Using Auto PI Seek for preset stations
When preset stations cannot be recalled, as
when travelling long distances, the unit can
be set to perform PI Seek during preset recall.
! The default setting for Auto PI Seek is off.
See Switching Auto PI Seek on page 14.
Limiting stations to regional
programming
When AF is used, the regional function limits
the selection of stations broadcasting regional
programs.
1 Press FUNCTION to select REG.
2 Press a or b to turn the regional func-
tion on or off.
Notes
! Regional programming and regional networks
are organized differently dependingon the
country (i.e., they may change according to
the hour, state or broadcast area).
! The preset number maydisappear from the
display if the tuner tunes ina regional station
which differs from the originallyset station.
! The regional function canbe turned on or off
independently for each FMband.
Receiving traffic announcements
TA (traffic announcement standby) lets you re-
ceive traffic announcements automatically, no
matter what source you are listening to. TA
can be activated for both a TP station (a sta-
tion that broadcasts traffic information) or an
enhanced other network’s TP station (a station
carrying information which cross-references
TP stations).
1 Tune in a TP or enhanced other net-
work’s TP station.
TP indicator will light.
2 Press TA to turn traffic announcement
standby on.
# Toturn traffic announcements standby off,
press TA again.
3 Use VOLUME to adjust the TAvolume
when a traffic announcement begins.
The newly set volume is stored in memory and
recalled for subsequent traffic announce-
ments.
4 Press TA while a traffic announcement
is being received to cancel the announce-
ment.
The tuner returns to the original source but re-
mains in the standby mode until TA is pressed
again.
# You can alsocancel the announcement by
pressing SOURCE, BAND, a, b, c or d whilea
traffic announcement is beingreceived.
Notes
! You can alsoturn the TA function on or off in
the menu that appearswith the pressing of
FUNCTION.
Operating this unit
En
9
English
Section
02
