Manual-8
©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 TEL 425-355-6000 FAX 425-347-7757 WEB www.rane.com
MP 2016S Mixer Port
is is the required socket to connect the XP 2016S to the MP
2016S, using the ribbon cable supplied with the XP 2016S. If
a ribbon longer that that supplied with the XP 2016S is used,
crosstalk may increase, and immunity to RF, magnetic and con-
ducted interference may be compromised. So don’t do it!
POWER
is power jack receives the cable from the RS 1 power supply
shipped with the unit. e chassis ground screw located just
above the jack is intended for earth grounding the chassis (see
the Chassis Grounding note on page Manual-4).
XP 2016S Ribbon Connections: (PIN 1 marked Ñ)
1) GND
2) GND
3) MIX RIGHT OUT
4) MIX LEFT OUT
5) GND
6) METER LEFT IN
7) METER RIGHT IN
8) GND
9) CH 6R IN
10) CH 6L IN
11) GND
12) CH 5R IN
13) CH 5L IN
14) GND
15) CH 4R IN
16) CH 4L IN
17) GND
18) CH 3R IN
19) CH 3L IN
20) GND
21) CH 2R IN
22) CH 2L IN
23) XP 2016 ENABLE (GND)
24) CH 1R IN
25) CH 1L IN
26) GND
Fader Cleaning
With heavy use in harsh environments, the faders may need
lubrication. is treatment extends longevity and can make used
faders as good as new. e fader assembly must be removed from
the XP 2016S for proper cleaning. We recommend any of the
following cleaning solutions:
Caig DeoxIT FaderLube
F100 spray lubricant (www .c aig.com)
Caig DeoxIT FaderLube F5 spray cleaner (www.caig.com)
CRC 2-26 (www.crcindustries.com)
Order DeoxIT® from:
CAIG Laboratories, Inc.
12200 atcher Ct.
Poway, CA 92064
Phone 858-486-8388
Fax 858-486-8398
Web www.caig.com
CLEANING INSTRUCTIONS
A. Fader assembly removal
1. Remove (2) 3mm screws.
2. Draw fader assembly out through hole.
3. Remove ribbon cable.
B. Fader cleaning
1. Hold the fader assembly away from the mixer.
2. Position the fader at mid-travel.
3. Spray cleaner/lubricant into both ends of the fader.
4. Move the fader over its full travel back and forth a few times.
5. Shake excess fluid from the fader assembly.
6. Wipe off excess fluid.
MP 2016S
MIXER
ACN 001 345 482
U.S. PATENT 7,043,032
MADE IN U.S.A.
RANE CORP.
XP 2016S
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
100-240 V
50/60 Hz 12 WATTS
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
