Regency® L676S Direct Vent Gas Fireplace 35
INSTALLATION
INSTALLATION
FACEPLATE & DOOR FRAME
INSTALLATION
1) Locate the 2 mounting brackets on either side of the glass door
frame.
Note: A 1/2" gap between the faceplate and
glass must be maintained all the way
around at all times.
Location of mounting brackets.
Level adjustment
Adjustment for fi nishing materials.
2) Install the Faceplate & Door Frame on the unit by hooking the left and
right side mounting tabs (on the faceplate) onto the mounting brackets
at either side of the glass doorframe as shown below.
3) If the Faceplate & Door Frame is not sitting level (fl at), remove and
adjust the 2 Phillips screws located at the bottom of the faceplate.
Factory Setting
3/4" Adjustment
3/8" Adjustment
5) The L676S Faceplate consists of 2 parts, an inner faceplate and an
outer faceplate, these 2 faceplates will be shipped installed together as
one piece. If necessary, the outer faceplate can be adjusted up to 3/4" to
allow for fi nishing materials. Remove 4 Phillips screws securing inner trim
to outer trim and relocate to appropriate position, retighten screws.
1/2" gap
Finished Facing Thickness Faceplate Adjustment
1/2" Factory Setting
1/2" - 7/8"(or less) Adjusted to + 3/8"
7/8" - 1-1/4" (or less) Adjusted to + 3/4"
