Remington's SPR 94 Manual

A SERVICE OF

next previous

Instructions For Disassembly Of The Combination Rifle/Shotgun

1. Make sure the shotgun is unloaded (FOLLOW UNLOADING INSTRUCTIONS)

and pointed in a safe direction.

2. Make sure the trigger block safety is engaged in the

“on” or “safe” position. (See

Picture 33).

3. Make sure the barrel assembly is locked into the receiver and the action closed. The top lever should

now be in the center position. The top lever should now be in the center position. Remove the forend

from the barrel by pulling out the mechanical lever in the lower center of the forend in a downward

outward swinging motion. (See

Picture 34). Never force the forend off the barrel and receiver.

4. With the barrel and receiver supported with one hand, push the top lever fully to the right and tip the

barrel assembly down until it disengages from the receiver. Check the barrels for

damage and obstructions after removal. (See

Pictures 35, 36 and 37).

15

Picture 33

Picture 35 Picture 36

Picture 37

Picture 34