- -
8
Selecting of Installation Locations
Indoor Unit:
• Intake and outlet should not be obstructed.
• The wall the unit is to be mounted on should allow for a clear hole for the condensation drain and the refrigeration
lines.
• The wall the unit is mounted on should be strong enough to bear the weight and vibration of the unit.
• Allow for proper clearances around the unit - see installation dimension diagram (page 5 and page 6).
• Location should allow easy access for maintenance and removal of air filter.
• Position unit and remote control at least 3 feet from electric appliances such as televisions, radios, etc.
• Keep unit and remote out of direct sunlight and/or florescent lighting and away from any excessive heat source,
steam, or flammable materials.
Outdoor Unit
• Allow sufficient ventilation around the unit - see installation dimension diagram (page 5 and page 6).
• The air intake and outlet should not be obstructed.
• Position unit so that noise and outlet airflow will not inconvenience neighbors.
• Position unit on a solid foundation. Location should be able to withstand the full weight and vibration of the unit.
• Installation should not be performed in the following locations exposed to: machine oil, flammable or corrosive
gases, high - frequency waves (i.e. from radio equipment, medical equipment, etc.)
Both Indoor and Outdoor Units:
Installation of Either unit in the following locations may cause malfunction. Locations exposed to:
• machine oil
• flammable or corrosive gasses
• high frequency waves (i.e. from radio equipment, medical equipment, etc.)
