3
STEP 9: ADJUSTMENT – CONTROL CABLES:
Both clutch cables should be slack when the control levers
are released. The cable spring on each control should
stretch 3/8" when each lever is depressed. To adjust cable,
loosen locking nut and turn cable connector as needed to
obtain the 3/8" extension. Tighten locking nut. See Figure
9.
FIGURE 9
STEP 10: ADJUSTMENT - CLUTCH CONTROLS:
A. Hold the traction clutch control lever down against
the handle (L.H. Side) See Figure 10.
B. Check position of the cam lock - it must align with
the adjusting line on the cam lock bracket.
C. To adjust, loosen the nuts on the cable guide
support bracket and move bracket in or out until the
cam lock aligns with the adjusting line. Tighten nuts.
D. Hold the traction clutch lever down while pressing
the blower clutch lever down into its engaged
position and hold.
E. Check the position of the cable ferrule shown in
Figure 10.
F. The ferrule shown in Figure 10 must be located
1/16" (.060) above the hook of the cam lock. To
adjust, loosen the three nuts on the cam lock
bracket and slide it up or down until adjustment is
correct. Tighten nuts and release both control
levers.
FIGURE 10
HOLD DOWN HOLD DOWN
TRACTION CLUTCH
CONTROL LEVER
BLOWER CLUTCH
CONTROL LEVER
(R.H. SIDE)
(L.H. SIDE)
CABLE GUIDE
SUPPORT BRACKET
CAM LOCK BRACKET
CABLE
CAM LOCK
CABLE FERRULE
.060
(1/16”)
CABLE
CAM LOCK HOOK
ADJUSTING LINE
(ON BRACKET)
CABLE GUIDE
“OUT”
“IN”
SPRING SHOULD
STRETCH 3/8”
WHEN LEVER IS
DEPRESSED
CABLE
CONNECTOR
CABLE SPRING
LOCKING
NUT
