Assembling the Roof Rake
and Adjusting the Handle
1. Unscrew the handle knob and extend the pole to expose
the small holes (Fig. 1).
2. Depress the small buttons at the end of the handle so
that you can insert the handle into the roof rake head
(Fig. 2).
3. Using the hex key wrench, screw the metal braces to the
roof rake head with the two short hex screws (Fig. 3).
4. Ax the metal braces to the pole by threading the long
hex screw through the metal braces and the pole. Secure
the screw with the locking nut using the open end wrench
(Fig. 4).
5. Lengthen the telescopic pole by rotating the handle knob
clockwise and extending the pole to the desired length.
Secure in position by twisting the knob counterclockwise
(Fig. 5).
NOTE: If you have any questions, please call the Snow Joe
®
+ Sun Joe
®
customer service department at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
EN
Fig. 1
Hole
Fig. 2
Buttons
Fig. 3
Hex key
wrench
Metal
braces
Short hex
screw
Short hex
screw
Fig. 4
Open
end wrench
Long hex
screw
locking
nut
Fig. 5
Handle
Knobs
Clockwise
to open
Counterclockwise
to close
3
