4-32
SAL35F14G (1.4/35G) (35mm F1.4G)
4) When the Near position check finishes normally, the message “Move FOCUS to Infinity position at about 5sec.” is displayed on the
pop-up window.
Set the focus to the infinity position and press down the ENTER key.
Fig.4-7-18
5) When the infinity position check finishes normally, “OK” is displayed on the pop-up window, and press the ENTER key to return to
the initial window.
Fig.4-7-19
3. In case of error display in the Focus Pattern (near position)
1) When the error display and the NG display appear to the pop-up window, press the ENTER key to return to the initial window, and
perform “2. Checking Method”again.
Fig.4-7-20
Fig.4-7-21
2) Although the lens is positioned at the near position, if “NG” appears, confirm or perform the following.
• 4-7-1. Focus Brush Position Check (Search Focus Adjustment Point)
• Cleaning of flexible pattern or the brush.
• Replaceing the brush.
• Rotating operation error of the focus ring (rotation speed is not suitable at a regulated speed.).
3) Perform “2. Checking Method”again, repeat the inspection until “OK” appears on the pop-up window.
