3. Drill starter hole inside of cutout line. 4. Using a saber saw, cut inside of cutout line. Trial fit sink to
check proper fit.
5. Fixture hole locations are identified with a gray label indicating
the most desired placement. Drill starter hole from reverse side.
Working from the top side as illustrated, position a hole saw on
the starter hole and drill to complete the fixture hole. Clean out
fixture hole with a knife or file. (See Caution). Attach faucet,
drain, and accessories according to manufacturer’s instructions.
CAUTION
Use of a hole saw is preferred, however, if punch is used, insure
that ledge is supported and punch is placed directly in middle of
knock-out area. If hole is not used, peel off the label.
6. Attach sink clips as illustrated to underside of sink. Sink clips
provided will accommodate a counter top up to 1-1/2Љ (38mm)
thick.
IMPORTANT
The Euro Style sink design allows for
the drainboard to be located on either
the left or right side. After you decide
on the location of the drainboard, the
fixture holes can then be located.
DRILL STARTER HOLE
INSIDE OF CUTOUT
LINE
CUT INSIDE OF LINE
NOTE
Drill Starter Hole From Bottom
Finish Drilling Hole From Top
Installation • Care and Cleaning
