A SERVICE OF

logo

Open as PDF
next previous
4
6
YAMAHA
MOST OTHER OUTBOARDS
3
3
SENSOR MUST BE
MOUNTED BEHIND
BRACKET
5
ARROW NOT
EXACTLY
AS SHOWN
Figure B
Figure A
Table 1
2
X
1
X = 4-7/8"
2
1
Discard item 2 after removal as it is NOT
to be used when SmartStick is installed.
If the SmartStick bracket
does not fit around the
steering cylinder bracket
contact Teleflex Canada
for replacement brackets.
NOTICE
NOTICE
NOTICE
NOTICE
DO NOT install the
sensor in front of the
mounting bracket.
Doing so will result in
interference with the
steering cylinder
(refer to Figure B).
Be sure to check for
interference at all
engine positions
before proceeding.
Discard item 2 after removal
as it is NOT to be used when
SmartStick is installed.
NOTICE
The sensor (item 4) may be
mounted in an inverted/flipped
position to allow the cable to
exit on the port side. In either
case the magnet arrow MUST
point in the same direction as
the arrow on the decal of the
sensor.
NOTICE
If interference occurs, check fit with other holes.
Model No. RED BLACK WHITE
AR4502, Furuno and Power (5 Volt) Ground Signal (0.5 V – 4.5 V)
most other autopilots
AR4502RM, Ray Marine Power (5 volt) Ground Signal (2.2 V – 2.8 V)
installations ONLY
AR4502SI, Simrad Power Ground N/A
installations ONLY
Using an assistant, check for unrestricted steering
articulation throughout engine trim/tilt positions.
The SmartStick rudder
reference unit will ONLY
mount to Evinrude and
Yamaha 4-Stroke engines
when using a HC5358
front mount cylinder.
CAUTION
WARNING