A SERVICE OF

logo

8
TM
9
TM
www.thetobi.com
HOW TO STEAM
Operating Steamer:
Add water according to OPERATING
INSTRUCTIONS section.
Plug steamer cord into electrical outlet. Power
indicator light will glow red.
When the Power indicator light goes off, the steamer
is ready to use.
Run steam plate or brush attachment evenly over
area to be steamed, pumping the steam button on
the handle up and down to release steam. When
steaming, touch material lightly with steam plate or
brush attachment and move up and down to remove
wrinkles. Continue to pump the button up and down
to maintain a consistent ow of steam. It is important
that you make contact with the garment and/or fabric
you are steaming.
The steamer can be used in any direction,
horizontally or vertically.
If water gets low, unplug steamer and allow to cool
completely. Next, remove water tank plug and add
more water without exceeding the maximum amount
of about 3 oz. Re-insert water tank plug securely
and resume use. DO NOT ALLOW THE WATER
TANK TO RUN ON DRY WHILE STEAMING, AS
THIS COULD DAMAGE YOUR STEAMER.
When steaming, your steamer’s power indicator light
will repeatedly go off and on. This is a normal part
1.
2.
3.
4.
5.
6.
7.
of its functioning as it constantly adjusts itself to the
optimal temperature.
For Best Results:
Some articles can be steamed better by steaming
from the underside.
Pants may easily be steamed holding them by the cuff.
When steaming, touch material lightly with steam
plate or brush attachment and move up and down
to remove wrinkles. It is important that you make
contact with the garment and/or fabric.
The Tobi™ travel steamer will not remove stains
from garments.
Never steam clothes while wearing them.
The Tobi™ travel steamer works on most fabrics,
including silk, denim, cotton, polyester and wool.
PLEASE REFER TO LABEL ON ITEM OF
CLOTHING TO CHECK IF GARMENT CAN BE
STEAMED. IN GENERAL, SOME FABRICS, E.G.,
LEATHER, SUEDE AND VELVET MAY NOT BE
SUITABLE FOR STEAMING.
TO ENSURE YOUR GARMENT IS SUITABLE FOR
STEAMING, STEAM A SMALL PART OF THE INSIDE
OF THE GARMENT TO TEST THAT IT DOES NOT
DAMAGE THE FABRIC BEFORE STEAMING THE EN-
TIRE GARMENT OR FABRIC.