56 Freedom SW Owner’s Guide
Configuring the Freedom SW using the SCP
Setting the Device Number
Setting the device number gives a Xanbus-enabled device a unique identity
when several devices of the same type are installed in the power system
network. When each identical device has a unique number, the Xanbus SCP
can correctly identify and display status information for each device.
A device number consists of two digits ranging from 00 (default) to 31.
If only one of each type of device is installed in the network, you do not
need to set the device number. However, setting the device number to a
value other than 00 is recommended in case you need to use the
Restore Defaults command (which resets the device number to 00).
After performing the command, checking that the device number has
returned to 00 indicates that the command was successfully completed.
To set the Freedom SW device number:
1. On the Freedom SW Setup menu, select Advanced Settings.
If Basic Settings appears instead of Advanced Settings on the
Setup menu, display Advanced Settings by pressing
Enter + Up arrow + Down arrow simultaneously.
On the Advanced Settings menu, select Stacking and press Enter.
2. On the Stacking menu, select Dev Number.
3. Press Enter to highlight the instance number.
4. Use the up and down arrow buttons to adjust the two-digit identifier
number.
5. Press Enter.
Figure 30
Setting a Device Number
FSW3012 00: Stacking
[00]
[01]
[1Ph Master]
Dev Name
Dev Number
Stack Mode
FSW3012 00: Stacking
Dev Name
Dev Number
Stack Mode
[00]
[*01]
[1Ph Master]
FSW3012 00: Stacking
[00]
[01]
[1Ph Master]
Dev Name
Dev Number
Stack Mode
3
5
4
Steps 1 and 2 are not shown.
Freedom SW 3K2K InvChg Owners Guide.book Page 56 Wednesday, October 9, 2013 1:34 PM
