Alphabetical reference Commands and Queries Reference
TOSET set the remote communication time out period.
Syntax TOSET <int>
Parameters the amount of time to wait between remote
communication events before a time out event is
declared. The allowed values are in the range 1 to
255 and the time units are seconds. A value of “0”
will not change the programmed time out period but
will cause the feature to be disabled (same as
“TOEN 0”).
Category System Type: Sequential
TOSET? return the programmed time out period of the remote communication
time out feature.
Syntax TOSET?
Parameters none
Category System Type: Sequential
TRIG program the Power Module’s reaction to a software or hardware
trigger.
Syntax TRIG <ch>,<int>
Parameters the number of the Power Module to be programmed.
the action to be performed by the Power Module
when a trigger is received:
0 = set output to values programmed while armed.
1 = toggle output on/off.
2 = initiate ramp to VSET programmed while armed.
3 = initiate ramp to ISET programmed while armed.
4 = output on.
5 = output off.
6 = no operation.
7 = un-arm.
Category Trigger and Sync Type: Sequential
TRIG? return the current reaction to trigger for the Power Module. Result is a
decimal number in the range 0 to 7.
Syntax TRIG? <ch>
Parameters the number of the channel to be queried.
Category Trigger and Sync Type: Sequential
TRIGER send a global trigger (to all Power Modules).
Syntax TRIGER
Parameters none
Category Trigger and Sync Type: Overlapped
64 XMP 2600 Programming Manual rev. 1.1
