139 En
TROUBLESHOOTING
English
ADDITIONAL
INFORMATION
After Auto Setup
• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “Auto Setup” again.
• If warning “W1” appears, corrections are made, but they may not be optimal.
• If warning “W2” or “W3” appears, no corrections are made.
• If error “E10” occurs repeatedly, please contact a qualified YAMAHA service center.
Warning message Cause Remedy
See
page
W1:Out of Phase Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the speaker connections for proper
polarity (+ or –).
16
W2:Over Distance The distance between the speaker and the
listening position is over 24 m.
Bring the speaker closer to the listening
position.
—
W3:Level Error The difference of volume level among
speakers is excessive.
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
—
Check the speaker connections.
16
Use speakers of similar quality.
—
Adjust the output volume of the subwoofer.
35
W4:SP Mismatch The result of the wiring check of “Auto
Setup” is different from “Speaker Set” in
“Manual Setup”.
Use “Speaker Set” in “Manual Setup” to
adjust the speaker settings manually.
96
Notes
