Filter
Top Products
2
3Com AP2750 Managed Access Point Features
Feature Description
Power Port The access point can be powered either via Power Over Ethernet (PoE), or by an
external power supply (not included) that is plugged into the Power
Port.
Serial Port The serial port is not supported.
Ethernet Port The Ethernet port provides a 10/100BASE-TX Ethernet connection to a 3Com Wireless
LAN switch. The connection can be direct to a 3Com switch or indirect through an
intermediate Layer 2 or Layer 3 network.
Use a standard Category 5 cable with straight-through signaling and standard RJ-45
connectors to connect the access point to the switch on the network.
LEDs The LEDs indicate power and activity. See “Checking the LED Indicators” on page 7
for details.
Antenna Connectors Two SMA-female antenna connectors allow you to connect antennas that operate in
2.4 GHz and 5.3 GHz bands.
Reset Button The reset button is accessible from the back of the access point as well as through the
mounting bracket. Push the reset button to restore the access point to its factory
default settings.
Mounting Bracket The mounting bracket comes attached to the access point. This mounting bracket
allows the access point to be mounted to a wall or ceiling.
Power Port
Serial Port
Ethernet Port
Mounting
Bracket
LEDs
Antenna
Connectors
Reset
Button