Filter
Top Products
5
The figures below show the mounting bracket being mounted to a wall, and then a cable
being routed through the large opening on the back of the mounting bracket.
4 Connect the Ethernet cable (and power cable, if applicable) to the port(s) on the
front of the access point.
5 Snap the access point onto the mounting bracket.
To install the locking bar, push the locking bar through the opening in the side of the
mounting bracket until the hole on the locking bar is exposed. Insert a lock (not provided)
through the hole on the locking bar, and then close the lock to secure it in place.
Installing the mounting bracket
Routing a cable
C
r
a
dl
e
Inserting the locking bar
Securing the bar with a lock
.11g
.100
.10
.11a
.11g
.100
.10
.11a