Anton/Bauer Two Position Charger Battery Charger User Manual


 
1
INTRODUCTION
The TWIN is a simultaneous Two Position charger for all Anton/Bauer
®
Gold Mount
®
Batteries. Its lightweight and small size makes it an ideal charger for travel. As a
simultaneous charger each position operates independently allowing two batteries to charge
at the same time (see battery charge times pg 5.).
The TWIN is fully compatible with all current and future Anton/Bauer Logic Series
®
batteries and delivers all the advancements and proven reliability of InterActive
®
charging.
Like all Anton/Bauer chargers, everything is automatic. Once a battery is placed on the
TWIN, the charger will evaluate the battery and then execute the proper charge routine.
STANDARD FEATURES
Simultaneous Charging for all Anton/Bauer Logic Series batteries.
Full InterActive technology including six simultaneous charge termination
systems, Balance and Rejuvenation modes, and LifeSaver
®
Maintenance mode.
Wide range mains input compatibility (90-250 VAC 50-60 Hz) automatically adapts
to any mains source worldwide.
Expanded InterActive communications with DIGITAL batteries, anticipating new
cell technologies.
Slim, ultra-lightweight design for easy portability.
This unit was packaged at the factory to arrive intact at its destination. If there
is any damage to the packaging or the unit when received, please notify the
carrier immediately.
SAFEGUARDS
Power Sources: This unit was designed to operate at mains voltages from
90 to 250 Volts AC, 50-60 Hz.
Risk of Electrical Shock: Refer servicing to qualified service personnel.
Important: When powering charger using a generator, the generator must
produce a
sine wave or modified sine wave output, otherwise the charger may be damaged.
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE.