Anton/Bauer Two Position Charger Battery Charger User Manual


 
5
attached. In this case, no indications will appear on the LED display.
Each TWIN constantly looks for such batteries, applying small, safe
amounts of charge current to each empty charge position. This search
mode occurs continuously.
CHARGE TIMES
Following are approximate charge times for Anton/Bauer Logic Series batteries.
ProPac 13/14 3 ½ hours
Digital ProPac 13/14 3 ½ hours
Trimpac 14 2 ¼ hours
Digital Trimpac 14 2 ¼ hours
ProFormer 1 ½ hours
HyTRON 50 2 ½ hours
HyTRON 120 6 hours
HyTRON 140 7 hours
Dionic 90 5 hours
Dionic 160 8 hours
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class A
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.
This equipment has been approved by one or more agencies. All changes and/or
modifications not expressly approved by Anton Bauer, Inc. could void the users’
warranty and authority to operate this equipment. There are no serviceable parts in
this equipment.
SPECIFICATIONS
Dimensions:
6.00” L x 5.50” W x 2.50” H
Weight:
18 ounces
Input Voltage:
90-250 VAC, 50-60 Hz
Anton/Bauer warrants the operation and specifications of this unit only when used
with Anton/Bauer batteries. Use of any other battery may be contrary to US Patent
Law and the International Safety Standard Approvals, which this unit carries.
The mains input of the TWIN is fused using a printed circuit board mounted device
that should be replaced ONLY by a qualified service technician.