NOTES:
11
USER GUIDE
10
Disclaimer of Warranties
Any user of this product does so at the user’s own risk. To the maximum extent permitted by
applicable law, Tekkeon, Inc. and its suppliers provide the hardware and any support services
related thereto “as is” and with all faults; and hereby disclaim all warranties and conditions,
whether express, implied or statutory, including, but not limited to implied warranties of
merchantability, fitness for a particular purpose, non-infringement, lack of negligence or
correspondence to description, except for those warranties specifically and expressly provided in
the Limited Warranty.
With respect to the use of this product, in no event shall the company be liable for any loss of profit
or any other commercial damage, including but not limited to special, incidental, consequential and
other damages.
Customer Support
If you product is in need of repair or replacement, please contact the Tekkeon Customer Support
Center at:
Tekkeon, Inc.
c/o myPower
3002 Dow Avenue, #218
Tustin, CA 92780
888-787-5888 / 714-832-1266
www.tekkeon.com
Tekkeon, Inc. will issue a Return Merchandise Authorization (RMA) number for all repairs or
exchanges.
3
USER GUIDE
Charging myPower
Before using myPower for the first time, you must charge it for three hours. Then you must recharge
myPower whenever all the green or red power capacity indicators on the front of the unit are off.
There are two ways to charge myPower: using the iPod power adapter, and through a 6-pin
FireWire port on your computer (if available).
As myPower is charging, the red and green lights on the front of the unit will turn on in sequence
from left to right. When myPower is charged to 65% capacity, the third green light turns on.
Continue to charge myPower for an additional 2 hours.
To charge myPower using the iPod power adapter:
1. Connect one end of the myPower FireWire cable into the iPod power adapter,
and plug the other end of the cable into the FireWire port on myPower.
2. Plug the power adapter into a working electrical outlet.
3. After three hours, unplug the power adapter as myPower will be fully charged.
(myPower will automatically shut down the power input when it is fully charged, so you can
charge it overnight.)
To charge myPower using the FireWire port:
1. Connect one end of the myPower FireWire cable into the FireWire port on your computer, and
plug the other end of the cable into the FireWire port on myPower.
2. After three hours, unplug the power adapter as myPower will be fully charged. (myPower will
automatically shut down the power input when it is fully charged, so you can charge it overnight.)
Note: FireWire ports on some Windows-compatible computers may be 4-pin FireWire ports that are
not powered (rather than 6-pin ports). A 4-pin port cannot charge myPower when it is connected to
that port. In this case, you need to charge myPower using the iPod power adapter.
2
Overview
myPower combines the power of a rechargeable battery with the convenience of
a portable dock. myPower gives you an extra 16 hours of extended play time so
now you can use just one device to charge and sync your iPod on the go. Because
myPower simultaneously charges and powers your iPod, you can enjoy non-stop
music—even when your iPod battery has nothing left to give.
Just plug and go to download music via myPower’s high-speed FireWire and USB
2.0 ports. You can even download music while you charge your iPod.
myPower is compatible with all 3G iPods (15G, 20G, 30G, and 40G) and all 4G
iPods (20G and 40G with Click Wheel).
Getting Started
Unpacking myPower
Your myPower package includes the following:
myPower
FireWire Port
Sizing Pads (4 sets)
myPower
with Belt Clip
USB 2.0 Cable
FireWire Cable