Filter
Top Products
9
• DO NOT CLICK THE TRIGGER OF A STALLED TOOL OFF AND ON IN AN ATTEMPT
TO START IT. DAMAGE TO THE TOOL CAN RESULT. To remove, twist the bit back
and forth and straight out.
• Minimize stalling on breakthrough by reducing pressure and slowly drilling through last
part of hole.
• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce
jamming.
• Make sure switch turns tool on and off.
WARNING: It is important to support work properly and to hold the tool firmly to prevent
loss of control which could cause personal injury.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could be
hazardous.
Troubleshooting
Problem
Possible Cause Possible Solution
• Tool will not charge. • Charger not plugged into • Plug charger into a
a working outlet. working outlet. Refer to
“Important Charging
Notes” for more details.
• Check current at
receptacle by plugging in
a lamp or other appliance.
• Check to see if
receptacle is connected to
a light switch which turns
power off when you turn
out the lights.
• Surrounding air temperature • Move charger and tool
too hot or too cold. to a surrounding air
temperature of above 40
degree F (4,5°C) or below
105 degree F (+40,5°C).
• Tool will not drill. • Clutch collar in wrong • Move collar position to
position. drill bit icon.
• Screws stripping • Clutch collar setting • Move collar position to
too high. a lower setting.
• Screws not fully seated. • Clutch collar setting • Move collar position to
too low. a higher setting.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
BATTERY REMOVAL
Before attempting to disassemble this tool, turn it on and run it in either direction until it
stops to ensure a complete discharge of the batteries. Using a phillips screwdriver,
remove the screws from the product housing and take the two body halves apart. Lift the
batteries out and pull off the terminal clips. See “Service Information” for battery
replacement and RBRC for battery recycling.
90544571 PD400 clutch sc 5/22/09 7:46 AM Page 9