Filter
Top Products
5
2. A dust mask or respirator should be worn by all persons entering the work
area. The filter should be replaced daily or whenever the wearer has difficulty
breathing. See your local hardware store for the proper N.I.O.S.H. approved
dust mask.
3. NO EATING, DRINKING or SMOKING should be done in the work area to
prevent ingesting contaminated paint particles. Workers should wash and clean
up BEFORE eating, drinking or smoking. Articles of food, drink, or smoking
should not be left in the work area where dust would settle on them.
ENVIRONMENTAL SAFETY
1. Paint should be removed in such a manner as to minimize the amount of dust
generated.
2. Areas where paint removal is occurring should be sealed with plastic sheeting of
4 mils thickness.
3. Sanding should be done in a manner to reduce tracking of paint dust outside the
work area.
CLEANING AND DISPOSAL
1. All surfaces in the work area should be vacuumed and thoroughly cleaned daily for
the duration of the sanding project. Vacuum filter bags should be changed frequently.
2. Plastic drop cloths should be gathered up and disposed of along with any dust
chips or other removal debris. They should be placed in sealed refuse receptacles
and disposed of through regular trash pick-up procedures. During clean up,
children and pregnant women should be kept away from the immediate work area.
3. All toys, washable furniture and utensils used by children should be washed
thoroughly before being used again.
Symbols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V .................. volts A ...................amperes
Hz ................hertz W ..................watts
min ..............minutes
................alternating current
............direct current
n
o .................no load speed
................Class I Construction ..................earthing terminal
(grounded)
................safety alert symbol
................Class II Construction opm ...............oscillations per minute
(double insulated)
• Whenusinganextensioncord,besuretouseoneheavyenoughtocarrythe
current your product will draw. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. The table shows the correct size to use
dependingoncordlengthandnameplateampererating.Ifindoubt,usethenext
heavier gauge. The smaller the gauge number, the heavier the cord.
Minimum Gauge for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50 51-100 101-150
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V 0-50 51-100 101-200 201-300
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More Not more American Wire Gauge
Than Than
0 - 6 18 16 16 14
6 - 10 18 16 14 12
10 - 12 16 16 14 12
12 - 16 14 12 Not Recommended