Filter
Top Products
6
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known in the state of California to cause cancer,
birth defects or other reproductive harm. Some examples of these chemicals are:
Your risk from these exposures varies, depending on how often you do this type
of work. To reduce your exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles
away from face and body. Always operate tool in well-ventilated area and provide
for proper dust removal. Use dust collection system wherever possible.
SYMBOLS
definitions are as follows:
V ..................volts A ................... amperes
Hz ................hertz W ..................watts
min ..............minutes
or AC .......alternating current
or DC ..direct current
n
o .................no load speed
................Class I Construction .................earthing terminal
(grounded)
.................safety alert symbol
................Class II Construction .../min or rpm ....revolutions or reciprocations
(double insulated) per minute
...........
Read instruction manual before use
................
Use proper respiratory protection
................Use proper eye protection .................
Use proper hearing protection
TO REDUCE THE RISK OF KICKBACK
causing a pinched blade.
Fig. F). Material supported only at the ends (Fig. E)
will lead to blade pinching.
figure H) and solidly supported and
balanced on a strong, stable and level work surface. Support the work so that the wide
portion of the saw shoe is on the portion of the material that doesn’t fall after the cut is
made. Never hold cut off piece by hand (figure G )
pressure treated and freshly cut green lumber can heavily load the saw which can lead
to stalling. Push the saw slower when this occurs.
saw with the blade against the work or pushed forward into cut can lead to stalling or
sudden backward movement of saw.