Filter
Top Products
7
ENGLISH
from the power source. In addition, except
the regular cleaning on your charger, no other
maintenance is needed.
u Regularly use the soft brush or dry cloth to
clean the ventilation slot of the equipment /
tools / charger.
u Regularly use a damp cloth to clean the motor
housing. Please do not use any abrasive clean-
ing agents or solvent-based cleansing agents.
u Regularly open the clamping chuck and tap it
gently to remove any internal dust (after instal-
lation).
Replace the carbon brushes (Fig. E)
Lubrication
u Regularly replace and check the carbon
brushes. Replace it in time when it is worn to
the abrasive boundary line. Keep the carbon
brush clean and make it freely slide in the
brushing range. Two brushes shall be replaced
at the same time.
u Use the cross screwdriver to counterclockwise
unscrew the screws, open the bottom cover(8)
with a at screwdriver to counterclockwise
open the brush cover(9), you can remove the
brush(10)as shown in the gure E, and put
the new brush, and then clockwise fasten the
brush cover(9), nally put the bottom cover(8),
and then use the cross screwdriver to tighten it
properly.
u Open the cap of the lube oil-injection inlet(2),
check the lube oil in the gearbox, if the lube
oil is dirty or insufcient, replace or add the
adequate amount of lube oil provided by the
company.
Cleaning
Warning! Once the visible dust build-up
is found at and/or around the ventilat-
ing ports, immediately ush the dust and
powder within the host shell with clean dry
air. To perform this procedure, wear the
approved safety equipment and dust mask.
Warning! It is strictly forbidden to clean
the non-metallic parts of the tool with the
solvents or other irritant chemicals. These
chemicals may weaken the materials of
these components. Use a cloth moistened
with a mild soapy water to clean it. Do not
let any substance permeate into the tool
and.do not immerse any part of the tool
into a liquid.
Protect the environment
Separate collection. This product may not
be disposed together with the ordinary
household waste.
If you nd that your Black & Decker products are
needed to be replaced or you will no longer need
to use these products, please do not put them
together with the household waste. Please place
them separately to recycle.
Separate collection of the used products
and packaging materials allow the
materials to be recycled and reused.
Reuse of the recycled materials helps to prevent
the pollution of the environment, and reduces the
demand for raw materials. Local regulations may
provide separate collection of the electrical
products from the household, at the municipal
waste sites or by the retailer when you purchase a
new product.