Filter
Top Products
3
The correct power tool will do the job better and safer at the rate for which it was
designed
.
b) Do not use the power tool if the switch does not turn it on and off.
Any power
tool
that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the
power
tool before making any adjustments, changing accessories, or storing
power
tools.
Such preventive safety measures reduce the risk of starting the power
tool
accidentally.
d) Store idle power tools out of the reach of children and do not allow persons
unfamiliar
with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts,
breakage
of parts and any other condition that may affect the power tools
operation.
If damaged, have the power tool repaired before use.
Many accidents
are
caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in accordance with these
instructions
and in the manner intended for the particular type of power tool,
taking
into account the working conditions and the work to be performed.
Use
of the power tool for operations different from those intended could result in a
ha
zardous situation.
5) Battery tool use and care
a) Ensure the switch is in the off position before inserting battery pack.
Inserting
the
battery pack into power tools that have the switch on invites accidents.
b) Recharge only with the charger specified by the manufacturer.
A charger that is
suitable
for one type of battery pack may create a risk of fire when used with another
battery
pack.
c) Use power tools only with specifically designated battery packs. Use of any
other
battery packs may create a risk of injury and fire.
d) When battery pack is not in use, keep it away from other metal objects like
paper
clips, coins, keys, nails, screws, or other small metal objects that can
make
a connection from one terminal to another.
Shorting the battery terminals
together
may cause burns or a fire.
e) Under abusive conditions, liquid may be ejected from the battery, avoid contact.
If
contact accidentally occurs, flush with water. If liquid contacts eyes,
additionally
seek medical help.
Liquid ejected from the battery may cause irritation
or
burns.
6) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement
parts.
This will ensure that the safety of the power tool is maintained.
SPECIFIC SAFETY RULES
• Wear ear protectors with impact drills. Exposure to noise can cause hearing loss.
• Hold tool by insulated gripping surfaces when performing an operation where the
cutting
tool may contact hidden wiring or its own cord. Contact with a "live" wire will
make
exposed metal parts of the tool "live" and shock the operator.
• When working on a ladder or on scaffolding be sure to lay the tool down on its side
when not in use. Some tools with large battery packs will stand upright but may be easily
knocked over.
• Use clamps or another practical way to secure and support the work piece to a
stable platform. Holding the work by hand or against your body leaves it unstable and
may lead to loss of control.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
90504485 CDC9602,CDC1200 etc 6/19/06 10:39 AM Page 3