Filter
Top Products
9
MAINTENANCE
Use
only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPOR
TANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment
(other than those listed in this manual) should be performed by authorized
service
centers or other qualified service personnel, always using identical replacement
parts
.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unit will not start. • Battery pack not installed properly. • Check battery pack
installation
.
• Battery pack not charged. • Check battery pack charging
requirements
.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
charger
until red LED
appears.
• Charger not plugged in. • Plug charger into a working
outlet. Refer
to “Important
Charging
Notes” for more
details
.
• Check current at
receptacle
by plugging in a
lamp
or other appliance.
• Check to see if
receptacle is connected to
a light switch which turns
power off when
you turn out the lights.
• Surrounding air temperature • Move charger and battery
too
hot or too cold. pack to a surrounding air
temperature
of above 40
degrees
F (4,5°C) or below
105
degrees F (+40,5°C).
For
assistance with your product, visit our website www.blackanddecker.com for the location of the
service
center nearest you or call the BLACK & DECKER help line at 1-800-654-155.
Accessories
Recommended
accessories for use with your tool are available from your local dealer or
authorized
service center. If you need assistance regarding accessories, please call:
1-800-654-144
.
WARNING: The use of any accessory not recommended for use with this tool could
be hazardous.
90504485 CDC9602,CDC1200 etc 6/19/06 10:39 AM Page 9