Black & Decker FSNS100 Staple Gun User Manual


 
2
WARNING: Read and understand all instructions. Failure to follow all instructions
listed below, may result in electric shock, fire and/or serious personal injury. The
symbols below are used to help you recognize this information.
indicates an imminently hazardous situation which, if not avoided,
will result in death or serious injury.
indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
used without the safety alert symbol indicates potentially
hazardous situation which, if not avoided, may result in property
damage.
SAVE THESE INSTRUCTIONS
Read and understand all warnings and operating instructions before
using any tool or equipment. When using tools or equipment, basic safety precautions
should always be followed to reduce the risk of personal injury. Improper operation,
maintenance or modification of tools or equipment could result in serious injury and
property damage. There are certain applications for which tools and equipment are
designed. Black & Decker strongly recommends that this product NOT be modified
and/or used for any application other than for which it was designed.
SAFETY GUIDELINES / DEFINITIONS
Read and understand tool labels and manual.
Failure to follow warnings could result in DEATH or
SERIOUS INJURY. (Fig. 1)
Operator and others in work area MUST wear
safety glasses with side shields. These safety
glasses must conform to ANSI Z87.1 requirements
(approved glasses have “Z87” printed or stamped on
them). (Fig. 2)
Keep fingers AWAY from trigger when not
driving fasteners to avoid accidental firing.
Never carry tool with finger on trigger. In "contact
actuation mode", tool will fire a fastener if tool is
bumped.
Choice of triggering method is important.
Check manual for triggering options. See “Using
the Tool“ section of this manual.
Fig. 2
Fig. 1
GENERAL SAFETY RULES
639224-00 FSNS100 Stapl 12/14/05 7:23 AM Page 2