Filter
Top Products
7
The FSNS100 Stapler is designed to install 18 ga. narrow crown staples of various
lengths from
3
/8" to 1" long. Narrow crown staples are loaded into the magazine from
the top.
POWER SOURCE
This tool is designed to operate on clean, dry, compressed air at regulated pressures
between 70 and 120 PSI (Pounds per Square Inch)
(4.8 to 8.3 BAR)
. The preferred
system would include a filter, a pressure regulator, and an automatic oiler located as close
to the tool as possible, within 15 ft/4.6 m is ideal.
All compressed air contains moisture and other contaminates that are detrimental to
internal components of the tool. An air line filter will remove most of these contaminates
and significantly prolong the life of the tool. If an in-line oiler is not available: place five or
six drops of air tool oil into the tool’s air inlet on a daily basis.
The tool is equipped with a
1
/4" male “quick connector”. The tool must always be
connected to the air supply with a coupling such that all pressure is removed from the tool
when the coupling is disconnected.
PREPARING THE TOOL
Keep tool pointed in a safe direction when loading nails.
Never load nails with the contact trip or trigger activated.
1. After reading and understanding this entire manual, connect tool to
air supply. (Fig. 22)
2. Depress latch and slide magazine cover open. (Fig. 23)
3. Insert a strip of approved fasteners. (Fig. 24) Orient fasteners with points down
in the magazine.
4. Push magazine cover closed. (Fig. 25)
5. Observe the low fastener indicator (A) Fig. 26 and reload as needed.
6. Adjust directional exhaust deflector (A) Fig. 27, so that the exhaust air
or debris will be directed away from the operator. Grasp the deflector
and rotate it to the desired position for the current application.
FUNCTIONAL DESCRIPTION
Fig. 22
Fig. 23
Fig. 24 Fig. 25
639224-00 FSNS100 Stapl 12/14/05 7:25 AM Page 7