Filter
Top Products
11
POCKET CUTTING
POCKET CUTTING IS USED TO CUT A
HOLE IN A PIECE OF MATERIAL
WITHOUT CUTTING FROM THE SIDE.
• Measure and mark work.
• Tilt saw forward and rest front of the
shoe on material to be cut. Align so
that cut will begin at the back of the
drawn rectangle shown in figure19.
• Using the retracting lever, retract
blade guard to an upward position,
with the blade just clearing the
material, start motor and gradually
lower the saw into the material.
WARNING: As blade starts cutting
the material, release the retracting lever
immediately.
• Never tie the blade guard in a raised
position.
• When the shoe rests flat on the
material being cut, complete the cut in
forward direction.
• Allow the blade to come to a complete
stop before lifting saw from material.
• When starting each new cut, repeat
the above steps.
WRENCH STORAGE
The blade wrench can be stored on the
saw shoe as shown in figure 20.
RIPPING
Your saw is not equipped with a rip fence.
If installing a rip fence, insure the fence
fits snug in slots.
If you do not have a proper fitting fence,
use a straight edge guide in contact with
the edge of the shoe to improve accuracy
of cut and reduce the possibility of binding
and kickback.
MAINTENANCE
Use only mild soap and damp cloth to
clean the tool. Never let any liquid get
inside the tool; never immerse any part
of the tool into a liquid.
IMPORTANT: To assure product
SAFETY and RELIABILITY, repairs,
maintenance and adjustment (other
than those listed in this manual) should
be performed by authorized service
centers or other qualified service
organizations, always using identical
replacement parts.
LUBRICATION
Black & Decker tools are properly
lubricated at the factory and are ready
for use.
ACCESSORIES
Recommended accessories for use with
your tool are available from your local
retailer.
WARNING:The use of any accessory
not recommended for use with this tool
could be hazardous. Use only 7-1/4 “
(184mm) blades with 5/8” diameter
arbor. Exception: 7" (175 mm) abrasive
blades can be used.
When cutting metal, be careful of hot
sparks which are thrown by the blade.
20
19
633145-02,01 QP1020LK 12/16/05 1:20 PM Page 11