Filter
Top Products
'/4:+4'4)+
+8</)+
8+<+4:/<+3'/4:+4'4)+
6+8,583+* (? ;4';:.
58/@+*6+89544+23'?8+9;2:/43/962')/4-
5,/4:+84'2=/8+9'4*)53654+4:9=./).
)5;2* )';9+ 9+8/5;9 .'@'8* We
recommend that all tool service be
performed by a Bosch Factory Service
Center or Autho rized Bosch Service Station.
!
Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
!
The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brush es be examined.
Only genuine Bosch replace ment brushes
specially designed for your tool should be
used.
Bearings which become noisy (due to heavy
load or very abrasive material cut ting) should
be replaced at once to avoid overheating or
motor failure.
2+'4/4-
5'<5/*'))/*+4:9'2='?9
*/9)544+)::.+:552,853
:.+65=+89;662?(+,58+)2+'4/4-58
6+8,583/4-'4?3'/4:+4'4)+ The tool may
be cleaned most effectively with compressed
dry air. 2='?9=+'89',+:?-5--2+9=.+4
)2+'4/4-:5529=/:.)5368+99+*'/8
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not at tempt to clean by inserting pointed
objects through openings.
+8:'/4)2+'4/4-'-+4:9
'4* 952<+4:9 *'3'-+
62'9:/)6'8:9 Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents, ammonia and house hold
detergents that contain ammonia.
!
WARNING
!
WARNING
!
CAUTION
-10-
in full contact with the work. Applying the
side or edge of the brush to the work will
result in wire breakage and shortened brush
life.
!!
Variable speed control must be used with
caution for driving nuts and bolts with socket
set attach ments. The technique is to start
slowly, increasing speed as the nut or bolt runs
down. Set the nut or bolt snugly by slowing the
drill to a stop. If this procedure is not followed,
the tool will have a tendency to torque or twist
in your hands when the nut or bolt seats.
CORRECT: Wire tips doing the work.
INCORRECT: Excessive pressure can cause wire breakage.
6+8':/4- /69A)54:
BM 1609929Y00 05-12_BM 1609929Y00 05-12 5/11/12 2:20 PM Page 10