Filter
Top Products
-9-
MICROFILTER DUST CANISTER
The integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
canister should be emptied frequently during
operation.
Your tool is equipped with
a dust canister, empty it
frequently, after completion of sanding
and before storing the sander. Be
extremely careful of dust disposal, materials
in fine particle form may be explosive. Do not
throw sanding dust on an open fire.
Combustion from mixture of varnishes,
lacquers, polyurethane, oil or water with dust
particles can occur if there is a static
discharge, spark introduced in the box, or
excessive heat.
REMOVING AND INSTALLING
DUST CANISTER
To attach dust canister, slide canister support
in direction of arrow (A) until it stops. Insert
mounting clip into the pocket provided on
canister. Then slide canister support through
mounting clip in direction of arrow (B) and push
onto the dust port (Fig. 4).
To remove dust canister, squeeze release
tabs on both sides of canister and simply pull
away from the tool (Fig. 5).
CLEANING AND EMPTYING THE
DUST CANISTER
To empty canister, hold canister and
maintain a firm grip (Fig. 7). Firmly push
upward on tab on corner of lid, and remove
from canister. Knock excess dust out of the
microfilter, or remove dust with your fingers
or a soft brush. You may notice that all the
dust may not come out of the canister. This
will not affect sanding performance but will
reduce dust collection efficiency.
NOTE: Do not wash the micro filter with soap
and water. Dust may become more firmly
lodged in the pores, which will reduce dust
collection, and damage the micro filter.
FIG. 4
CANISTER SUPPORT
DUST PORT
MOUNTING CLIP
A
B
!
WARNING
FIG. 5
RELEASE
TABS
MICROFILTER
DUST
CANISTER
FIG. 6
FIG. 7
BM 2609932486 01-12:BM 2609932486 8-05 1/26/12 7:22 AM Page 9