Filter
Top Products
-37-
%'$!"
Blade does not completely cut
workpiece.
Head assembly does not slide
freely when attempting a slide
cut.
Head assembly slides forward
and back when making a chop
cut.
Bevel setting does not hold
position.
*(
1. Depth stop screw adjusted
for groove cutting.
1. Slide rail lock knob tight-
ened.
2. Slide rail lock knob not tight-
ened.
1. Bevel lock lever assembly
needs to be tightened.
$'')+)$#
- See Depth Stop Adjustment
in the Adjustment section.
- Loosen slide rail lock knob.
- Push head assembly com-
pletely against stop. Tighten
slide rail lock knob.
- Tighten bevel lock lever as
shown on page 13.
)A>D1;4B7>>C8=6
)A>D1;4B7>>C8=6D8344=4A0;
224BB>A84B
"8C4A8=34AK868C0;=6;458=34A><
?>D=3DC0;2D;0C>A%A>CA02C>A!4E4;– Gives
you the information needed to position cuts so that
they fit together precisely even if the room is out of
square.
"( >A8I>=C0;&D82:;0<? A>F=(C>?
A02:4C– Clamps workpiece against fence. Can
also be used as a crown molding stop. Mounts to
left or right side of the table.
"(GCA0!>=60B4'>3 8C – Consists of
replacement steel rods that extend the total width of
base to 5 ft. (60).
"(!4=6C7(C>? 8C
"('4?;024<4=C 4A5=B4ACB
"('4?;024<4=CDBC06
"('4?;024<4=C+4AC820;&D82:;0<?
))A02'02K%>AC01;4(C0=3F8C7,744;B
)A0E8CH'8B4,744;43"8C4A(0F(C0=3
2610009642 10/09 E:2610009642 10/09 E 10/20/09 3:19 PM Page 37