Filter
Top Products
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position (Fig. 1).
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward.
Press the battery pack release button again
and slide the battery pack completely out of
tool housing (Fig. 1).
-13-
The combination blade provided with your saw
is for both cross cuts and rip cuts. Ripping is
cutting lengthwise with the grain of the wood.
Rip cuts are easy to do with a rip fence
(Fig. 13). To attach fence, insert fence through
slots in foot to desired width as shown and
secure with the knob.
'5&3"55"$)*/(03"%+645*/(
5)&3*1'&/$&#&463&5)&
3*1'&/$&%0&4/05506$)03*/5&3'&3&8*5)
5)&'3&&.07&.&/50'5)&-08&3(6"3%03
$0/5"$55)&4"8#-"%&
When rip cutting large sheets, the rip fence
may not allow the desired width of cut. Clamp
or nail a straight piece of 1" (25 mm) lumber to
the sheet as a guide (Fig. 14). Use the right
side of the foot against the board guide.
FIG. 13
FIG. 14
RIP
FENCE
KNOB
DESIRED
WIDTH
OF CUT
DESIRED
LINE
OF CUT
RIP
BOARD
GUIDE
!
!
WARNING
BM 2610034442 03-14_CCS180 3/27/14 12:25 PM Page 13