Filter
Top Products
-14-
$$&4403*&4
(*= standard equipment)
(**= optional accessories)
* rip fence
* 6-1/2" thin kerf 18 tooth carbide blade
** 6-1/2" thin kerf 24 tooth carbide blade
"*/5&/"/$&
&37*$&
3&7&/5*7&
."*/5&/"/$&1&3'03.&%#:6/"65)03*;&%
1&340//&-.":3&46-5*/.*41-"$*/(0'
*/5&3/"-8*3&4"/%$0.10/&/548)*$)
$06-%$"64&4&3*064)";"3% We recom -
mend that all tool service be performed by a
Bosch Factory Service Center or Authorized
Bosch Service Station. SERVICE MEN:
Disconnect tool and/or charger from power
source before servicing.
&"-&35'03#"55&3:1"$,45)"5"3&/&"3*/(
5)&*3&/%0'-*'& If you notice decreased tool
performance or significantly shorter running
time between charges then it is time to
replace the battery pack. Failure to do so can
cause the tool to operate improperly or
damage the charger.
Your Bosch tool has been properly lubricated
and is ready for use.
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six
months. Only a genuine Bosch replacement
motor specially designed for your tool should
be used.
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating and
motor failure.
-&"/*/(
0"70*%"$$*%&/54"-8":4
%*4$0//&$55)&500-"/%03
$)"3(&3'30.5)&108&34611-:#&'03&
$-&"/*/( The tool may be cleaned most
effectively with com pressed dry air. -8":4
8&"34"'&5:(0((-&48)&/$-&"/*/(500-4
8*5)$0.13&44&%"*3
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
&35"*/$-&"/*/("(&/54
"/% 40-7&/54 %"."(&
1-"45*$1"354 Some of these are: gasoline,
car bon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
!
WARNING
!
WARNING
!
CAUTION
BM 2610034442 03-14_CCS180 3/27/14 12:25 PM Page 14