Filter
Top Products
English - 2
The numbering of the device elements refers to
the illustration of the machine on the graphics
page.
While reading the operating instructions, unfold
the graphics page for the device and leave it
open.
1 Thumbwheel for speed preselection
(GWS 6-100 E, GWS 6-115 E,
GWS 8-100 CE, GWS 8-115 CE,
GWS 8-125 CE)
2 On/Off switch
3 Auxiliary handle
4 Spindle lock button
5 Grinder spindle
6 Protection guard
7 Screw
8 Mounting flange
(for the M 14 grinding spindle with O-ring)
9 Grinding-/cutting disc*
10 Clamping nut
11 quick-clamping nut*
(for M 14 grinder spindle)
12 Hand guard*
13 Rubber sanding plate*
14 Sanding sheet*
15 Round nut*
16 Cup brush*
17 Mounting flange M 10
* Not all of the accessories illustrated or described are
included as standard delivery.
Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the ma-
chine are: Sound pressure level: 89 dB (A);
sound power level: 102 dB (A).
Wear hearing protection!
The typically weighted acceleration is 5.0 m/s
2
.
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is re-
quired.
For machines with electronic control: With ap-
proved sanding tools, the machine can be used
for sanding and polishing.
Slots in structural walls are subject to the Stand-
ard DIN 1053, Part 1 or country-specific regula-
tions.
These regulations are to be observed under all
circumstances. Before beginning work, consult
the responsible structural engineer, architects or
the construction supervisor.
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the enclosed booklet
must be observed. Before using for the first
time, ask for a practical demonstration.
■ Wear protective glasses and hearing protec-
tion.
■ Wear additional protection equipment for your
safety, such as protective gloves, sturdy
shoes, hard hat and apron.
■ The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
■ Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of
materials are particularly dangerous.
■ If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Machine Elements
Noise/Vibration Information
Intended Use
Information on Structures
For Your Safety
2 609 140 081 - Buch Seite 2 Dienstag, 20. Januar 2004 8:52 08
14 • 2 609 140 081 • TMS • 15.01.04