Filter
Top Products
-21-
Accessories
If an extension cord is
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used.
This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
!
WARNING
PR002 Straight Router Guide*
†
PR003 Roller Guide
†
PR004 Offset Base with Trim Guide
†
PR005 Tilt Base
†
PR006 Underscribe Attachment
†
PR007 Side-Handle Subbase with Dust
Extraction Hood
PR008
Base Cover
PR009 Round Subbase for RA-Series
Templet Guide
PR010 Round Subbase for Threaded
Templet Guide
83038 Hinge Templet Kit
Router Bits
Case*
†
Vacuum Hoses
Vacuum Hose Adapter
*Included with PR20EVSK
†
Included with PR20EVSNK
Tool’s
Ampere
Rating
Cord Size in A.W.G.
Wire Sizes in mm
2
3-6
6-8
8-10
10-12
12-16
18 16 16 14 0.75 0.75 1.5 2.5
18 16 14 12 0.75 1.0 2.5 4.0
18 16 14 12 0.75 1.0 2.5 4.0
16 16 14 12 1.0 2.5 4.0 —
14 12 — — — — — —
25
50
100
150 15
30
60
120
C
ord Length in Feet Cord Length in Meters
Cleaning
To avoid accidents always
disconnect the tool from
the power supply before cleaning or
performing any maintenance.
The tool may
b
e cleaned most effectively with compressed
d
ry air.
A
lways wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
Certain cleaning agents
and solvents damage
plastic parts.
Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
!
WARNING
!
CAUTION
BM 2609140437 05-06 5/23/06 3:15 PM Page 21