Filter
Top Products
-8-
:/<+>3818=><?->398=
==/7,6C
The Bosch model PS21 Cordless Drill/Driver
h
as a chuck that accepts any 1/4" hex bit.
T
he
low RPM capability of this model is not a
deficiency. On the contrary, low speed means
high torque and high torque is a definite plus for
efficient drilling and driving. The low speed also
provides more control to prevent stripout of the
screw and damage to the work surface.
#"$" &## "#
To avoid loss of control,
ensure bit is locked in chuck
by pulling on bit after it has been inserted.
Your tool is equipped with a quick release
chuck. To insert an accessory, simply pull
locking sleeve forward, insert desired accessory
into chuck until the locking sleeve retracts
automatically, locking the bit (Fig. 2).
To remove an accessory, pull locking sleeve
forward and simply remove it from the chuck.
8/38-2,3>==29?6.986C,/?=/.+6981
A3>2+,3>296./<+==29A838031?</
!" $$ #$!
#"
The lithium ion battery is protected against
deep discharging by the “Electronic Cell
Protection (ECP)”. When the battery is empty,
the tool is switched off by means of a
protective circuit.
&"#! $"
$""#'$
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
"'""&"#
&"$""
After tool use, lock trigger in
“OFF” position to help prevent
accidental starts and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 3). This lever was designed
for changing rotation of the bit, and for locking
the trigger in an “OFF” position.
For forward rotation, (with chuck pointed
away from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to
the center off position.
989>-2+81/.3</->39890
<9>+>398 ?8>36 >2/ >996
-97/=>9+-97:6/>/=>9:Shifting during
rotation of the chuck can cause damage to
the tool.
!
WARNING
FIG. 3
!
CAUTION
!
WARNING
CHUCK
FIG. 2
LOCKING
SLEEVE
HEX-SHANK
DRILL BIT
SCREWDRIVER
BIT
BIT HOLDER
BM 2610007871 12-09:BM 2610007871 12-09 12/17/09 7:25 AM Page 8