Filter
Top Products
@
Your tool is equipped with a convenient hook
for hanging your tool. To use, simply open
hook until it snaps into the open position
(Fig. 7).
!,)297-2+8,)@%0;%=7
&)%;%6)8,%88,)%'')7736=-7)<437)(
Always hang the tool in an area where
yourself and bystanards can not accidently
make contact with the accessory.
3 6)(9') 8,) 6-7/ 3*
-2.96= 97) '%6) -2
7)0)'8-2+8,)03'%8-32*36,%2+-2+8,)
8330
Select a suitably sized and shaped object
that will provide adequate hanging stability.
An unstable hanging surface could result in
the tool unexpectedly falling.
Insure that the tool is hung out of the way of
walkways and working areas with
bystanders. The tool could be bumped or a
bystander could become entangled in the
power supply cord causing the tool to
unexpectedly fall.
3 6)(9') 8,) 6-7/ 3*
-2.96= 3 238 97) 8,)
,%2+-2+,33/-*-8%44)%67(%1%+)(36
()*361)(,-7'390(6)7908-29278%&0)
,%2+-2+%2(8,)833092)<4)'8)(0=*%00-2+
!,)2238-297)%0;%=7
'037),33/928-0-872%47
-2838,)'037)(437-8-32
@
FIG. 7
34)2
3037)
!
WARNING
!
WARNING
-10-
The selector dial allows the tool to be set for
various drilling/hammer drilling applications.
Depress release button and turn selector dial
right or left depending on the below
applications.
When using demolition or chipping bits such as
bull points, chisels, spades, gouges, etc. the
“Hammer Only” mode must be selected.
323834)6%8)8,)7)0)'8-32
(-%0928-08,)8330'31)83%
'3140)8)7834 Shifting during rotation of the
chuck can cause damage to the tool.
A B
Adjusting the Vario-Lock: The vario-lock can
be set in any one of 40 (9˚ increments)
positions. Choose a position which is best
suited for your operation.
Depress release button and turn the selector
dial, to the “vario-lock” setting. Next, rotate
the locking sleeve, along with the accessory,
to the desired position. Then turn the selector
dial to the “hammer only” setting and slightly
turn the locking sleeve to have it
automatically lock into a definite position.
!
CAUTION
6-00-2+320= 6-00-2+,%11)6-2+ %6-303'/ %11)6-2+320=
used for drilling used for drilling allows for 40 desired used for light
wood, steel, etc. concrete positions of the “chisel” chipping work
FIG. 6
BM 1619929E69 03-11:BM 1619929E69 03-11.qxp 3/28/11 2:03 PM Page 10