Filter
Top Products
-10-
6@0<;;20A/.AA2?F=.08
3?<: A<<9 <? =9.02 A52
@D6A056;A529<0821<?<33=<@6A6<;/23<?2
:.86;4.;F.@@2:/9F.17B@A:2;A@<?
05.;46;4.002@@<?62@ Such preventive
safety measures reduce the risk of starting the
tool accidentally.
"&' "&&=9B@
H
&&#%&
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant
Insert accessory into the chuck through the
dust shield, while twisting and pushing inward
until it locks automatically into place. Pull
outward on the accessory to be certain it is
locked into the chuck (Fig. 2).
"#' The high efficiency available from the
rotary hammers can only be obtained if sharp
and undamaged accessories are used. The
"cost" to maintain sharp and undamaged
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
%!#)"&&=9B@
H
&&#%&
Accessories may be hot after
use. Avoid contact with skin
and use proper protective gloves or cloth to
remove.
To remove an accessory, pull locking sleeve
backward and pull bit forward. All accessories
should be wiped clean after removing (Fig. 3).
1
2
3
2
1
FIG. 2
FIG. 3
DUST
SHIELD
LOCKING
SLEEVE
!
WARNING
@@2:/9F
!
WARNING
6@0<;;20A/.AA2?F=.08
3?<: A<<9 <? =9.02 A52
@D6A056;A529<0821<?<33=<@6A6<;/23<?2
:.86;4.;F.@@2:/9F.17B@A:2;A@<?
05.;46;4.002@@<?62@ Such preventive
safety measures reduce the risk of starting the
tool accidentally.
"&' "%!#)"*(
"<A6;09B121.C.69./92.@.002@@<?F
The 3 Jaw Chuck
with SDS Shank
can convert your
tool for use with
straight shank
bits (Fig. 4).
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant
Insert accessory into the chuck through the
dust shield, while twisting and pushing inward
until it locks automatically into place. Pull
outward on the accessory to be certain it is
locked into the chuck (Fig. 5).
To remove the chuck, pull the locking sleeve
backward (towards the rear of tool), while
pulling the chuck forward.
!
WARNING
1
2
3
LOCKING
SLEEVE
3-JAW CHUCK
(Not included, available
as accessory)
FIG. 4
FIG. 5
BM 2610028048 12-12_BM 2610028048 12-12.qxp 12/5/12 10:27 AM Page 10