Filter
Top Products
Accessories
If an extension cord is
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used.
This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
!
WARNING
* 360° Auxiliary Handle
* Depth Gauge
* 3-Jaw Chuck Adapter
(Model 11258VSRC only
* Carrying Case
(*= standard equipment)
Tool’s
Ampere
Rating
Cord Size in A.W.G.
Wire Sizes in mm
2
3-6
6-8
8-10
10-12
12-16
18 16
16
14
0.75 0.75 1.5 2.5
18
16
14
12 0.75 1.0 2.5 4.0
18
16 14 12 0.75 1.0 2.5 4.0
16 16
14
12 1.0 2.5 4.0 —
14
12
— —————
25 50 100 150 15 30 60 120
Cord Length in Feet Cord Length in Meters
-11-
Cleaning
To avoid accidents always
d
isconnect the tool from
t
he power supply before cleaning or
p
erforming any maintenance.
T
he tool may
be cleaned most effectively with compressed
dry air.
Always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
o
bjects through openings.
Certain cleaning agents
and solvents damage
plastic parts.
Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household
detergents that contain ammonia.
!
WARNING
!
CAUTION
BM 1619P00836 12-06 1/5/07 9:43 AM Page 11