Filter
Top Products
-6-
!9*5
99&(-!:55479.3088*2'1>
1. Unfold stand from vertical position:
With one hand on the handle, foot on the
kick bar, pull back slightly and rotate the
release lever to disengage the locking pins.
With both hands on the handle, pull back,
push down, and lower the stand until it
locks in position.
2. Locate the support link assembly and
assemble as shown in figure 4. Note the
“R” and “L” stickers for proper orientation.
3. Place one (1) 10mm flat washer (P) onto
one (1) 10mm x 100mm bolt (I).
4. Insert bolt through wheel/leg assembly and
place one (1) 10mm flat washer (P) on bolt
between wheel/leg and support link
assemblies.
5. Insert bolt through support link assembly,
place one (1) 10mm flat washer (P), and
loosely tighten with one (1) 10mm lock nut
(S).
49* Do not over-tighten lock nut. These
parts need to freely rotate for stand to
operate properly.
Repeat this procedure for the opposite side.
FIG. 4
!9*5
99&(-.(0&7
1. Locate the kick bar and position it between
the left and right wheel/leg assemblies as
shown in figure 3.
2. Place one (1) 10mm x 29mm OD flat
washer (O) onto one (1) 10mm x 50mm
Nylock hex head bolt (K). Insert bolt
through the wheel/leg assembly and
thread it into the the kick bar and securely
tighten.
Repeat this procedure on other side.
FIG. 3