Filter
Top Products
FLASHTUBE ASSEMBLY REPLACEMENTMOUNTING RINGFLASH PRO TO LIGHT STAND
STEP 1.) Mount the Camera Bracket to the selected support system as shown in fig. 1.
S
TEP 2.) Once the Ringflash Pro is mounted onto the selected support system, simply tighten the mount screw as shown in fig. 2 to hold in
position.
f
ig.1 fig.2
MOUNTING RINGFLASH PRO TO CAMERA STAND
ST
EP
1.) To mount the Ringflash Pro to a camera stand, first place the brass spigot on top of the camera plate and fasten to the camera
mounting thread as shown in fig. 3.
STEP 2.) Next place the Ringflash Pro camera bracket on top of the brass spigot and lock in place by tightening the thumb screw as shown
in fig.4.
S
TEP 3.) Attach the Ringflash Pro to the camera bracket as shown in fig. 5 and secure in place using the thumb screws provided.
N.B. When attaching the Ringflash Pro to the camera bracket ensure that the Ringflash Pro handle is positioned to one side to
allow the Ringflash Pro complete freedom of movement without the handle coming into contact with the camera stand.
S
TEP 4.) Once the Ringflash Pro is secured in place, next attach the camera to the camera bracket. Your setup should appear as shown in
fig.6.
fig.3 fig.4 fig.5 fig.6
WARNING HIGH VOLTAGE
AFTER USE DO NOT TOUCH THE FLASHTUBE ASSEMBLY FOR THIRTY MINUTES DUE TO EXTREME HEAT
STEP 1.) Ensure that the Ringflash Pro is switched off and disconnected from the mains supply and wait for thirty minutes to allow to cool
down before touching / removing the flashtube.
S
T
EP
2.) Before removing the flashtube assembly from the Ringflash Pro first remove the front protective glass cover (before removing
check the glass has cooled sufficiently to touch). Once the glass cover has been removed take out the two modelling lamps
next to the trigger wire tab and then unwind the trigger wire from the tab as shown in fig. 7. It is recommended to remove the two
modelling lamps next to the trigger wire tab to allow more room to when unwinding the trigger wire and so not to damage the
lamps.
S
T
EP
3.) To remove the flashtube assembly hold gently on both sides and pull away evenly from the Ringflash Pro as shown in fig. 8. To
replace the flashtube assembly, simply place all four support legs into the correct fittings and gently push back in ensuring all four
legs are placed back in evenly and secured by fully inserting into the flashtube leg connections.
N.B. Always replace with the correct flashtube assembly.
fig.7 fig.8
MODELLING LAMP REPLACEMENT
WARNING HIGH VOLTAGE
AFTER USE DO NOT TOUCH THE MODELLING LAMPS FOR THIRTY MINUTES DUE TO EXTREME HEAT
STEP 1.) Ensure that the Ringflash Pro is switched off and disconnected from the mains supply and wait for thirty minutes to allow to cool
down before touching / removing the modelling lamps.
S
TEP 2.) Before removing any modelling lamps from the Ringflash Pro first remove the front protective glass (before removing check the
glass has cooled sufficiently to touch). To remove the modelling lamps grip gently between fingers (always ensure that you do not
touch the modelling bulbs directly with your fingers, use a cloth or a tissue (as shown in fig.9.), this is because the residue from
your fingers can shorten the life span of the bulb) and pull away slowly from the Ringflash Pro. To replace the modelling lamps
simply align the two legs of the lamp with the correct fittings and gently push in ensuring that the lamp legs are fully inserted.
fig.9
3 4