Filter
Top Products
Step 5: Holding the front housing secure, slowly lift the rear housing off.
Step 6: Pull reflector away from rear housing being careful not to pull
wire connections inside. Do not touch the inside of reflector.
NOTE: The glass lens is not attached to front housing. Use care when
disassembling to avoid breaking lens.
Step 7: Pinch the ends of the wire retainer together and lift up
as illustrated.
Step 8: Pull bulb straight out from the reflector mounting plate.
Step 9: Disconnect bulb wire from connector by holding the connector
firmly with fingers then pulling bulb wire straight out.
Step 10: To install new bulb, grasp the bulb from the metal end (DO NOT
TOUCH THE GLASS PART) and insert into the reflector mounting
plate. Align the slots in the bulb base with those in the reflector
mounting plate.
Step 11: Replace wire retainer by pinching ends together while
pressing down. Push ends apart so they catch on the
reflector mounting plate.
Step 12: Reconnect the bulb wire to the connector as illustrated.
Step 13: To reassemble, place the front housing face (lens) down on a
flat surface. Set the reflector into the rear housing. Insert the
rear housing into the font housing of the spotlight.
Step 14: Replace the two screws that were removed in Step 3. Do not
over tighten screws.
Replacement bulbs may be purchased from The Brinkmann Corporation
Customer Service Department by calling 800-468-5252.
Connector
5
Connector
INS_800-1620-0_BlueMaxRech.qxd 10/14/05 10:50 AM Page 6