Filter
Top Products
Page 3
3. Technical Data
Dimensions (L x H x W): approx. 11 13/16” x 9 15/32” x 2 17/32”
(Approx. 300 x 240 x 65 mm)
Total weight: approx. 3 lbs. (1.4 Kg)
Connection cable with mains plug: 10 ft (3 m) long
Operating voltage: 110-120 VAC 50/60Hz
Power consumption 500W
Heating up time: 10 minutes
Operating temperature: 175-SPRAY approx. 356°F (180°C)
175-SPRAY-HT approx. 383°F (195°C)
Diameter of adhesive inlet: 1 11/16” (43 mm)
Extension cable: max. 65ft (20 m) long
Wire cross section: at least 16 a.w.g. (1.5 mm
2
)
Air Supply / Pneumatic Minimum - 45 p.s.i. (3 bar)
Maximum - 100 p.s.i. (7 bar)
Approximate Spray Pattern Minimum Maximum
Ultra Wide Spray Pattern / 985216 1 ½” [38mm] 6” [150mm]
Wide Spray Nozzle Assembly / 985122 1 ¼” [32mm] 5” [127mm]
Narrow Spray Pattern Assembly / 985211 ½” [13mm] 1 ¼”[32mm]
4. Installation
Before using the tool for the first time check it carefully for signs of external damage. If
any transit damage is found DO NOT USE THE TOOL - return it to your supplier
immediately.
Steps 1 – 5 should be followed before connection to the mains supply:
1. Insert the applicator stand into the grooves at the base of the handle. Stand
applicator on a flat surface.
2. Connect the air supply hose to a clean, dry and regulated air supply using the
Quick-Disconnect fitting provided (use of a filter/regulator is recommended)
3. Pull piston back fully and rotate upwards.
4. Load two adhesive cartridges into the barrel of the tool and push fully forward.
5. Rotate the piston down and slide forward fully until it contacts the rear of the
adhesive cartridge - it should engage about 5/16" (6-8mm) into the applicator
barrel.
6. Connect tool to mains supply.
7. Red ‘Power On’ indicator light illuminates.
2
3
5
1
4
USERS AIR SUPPLY