Filter
Top Products
5
The 4 LED charge indicators on the INPUT end of the battery cylinder (A)
allow you to monitor the status of the BatteryBar’s internal battery. While
the battery is charging from the AC wall charger, the LEDs will light up in
sequence to show the charge level as shown in Fig. 1. The LED indicating
the current battery level will blink rapidly while charging. When charging is
complete, all LEDs remain on for 10 min., then shut o until the Power button
is pressed.
While the BatteryBar is charging your connected device (Power button must
be pressed), the LEDs will monitor the BatteryBar’s battery level as shown in
Fig. 2, with a single LED blinking once every 15 sec. (shows active charging but
conserves battery power).
You can also check the current level of the BatteryBar’s battery charge
anytime by pressing the Power button, even when it is not connected to
the charger or an external device. The LEDs will glow steadily to indicate the
charge level % as shown in Fig.3. , then shut o after 10 seconds.
Fig. 1
Charging In
from AC
>25% >50% >75% >90% FULL
Blinking
<25% >25% >50% >75% FULL
Fig. 3
Checking
Charge Level
Blinking
<25% <50% <75% <90% FULL
Fig. 2
Charging Out
to Device
Slowly Blinking
UNDERSTANDING THE POWERSYNC POWER GAUGE