Filter
Top Products
20
Notes
Notes
Notas
Operating Instructions and Parts Manual DG190600CK S
Variable Speed
Hammer Drill
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain
the product described. Protect yourself and others by observing all safety information. Failure to comply with
instructions could result in personal injury and/or property damage! Retain instructions for future reference.
IN713300AV 3/06
For parts, product & service information
visit www.chpower.com
BUILT TO LAST
© 2006 Campbell Hausfeld/Scott Fetzer
See Warranty on page 6 for important information about commercial use of this product.
Description
Hammer drills provide short, rapid
hammer thrusts at the same time the bit
turns. By adding impact to the drilling
tip, the material is actually pulverized,
increasing the efficiency of the drilling
process and keeping the tip of the bit
cooler. This hammer drill can be used in a
normal drilling mode as well. Other
features include variable-speed and
reversing controls, which provide the
ability to use the drill as a driver as well.
The depth stop offers greater control,
project versatility, and increases depth
accuracy.
Unpacking
When unpacking this product, carefully
inspect for any damage that may have
occurred during transit.
General Safety
Information
This manual contains information that is
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROBLEMS.
To help recognize this information,
observe the following symbols.
Danger indicates
an imminently
hazardous situation which, if not
avoided, will result in death or serious
injury.
Warning indicates
a potentially
hazardous situation which, if not
avoided, could result in death or serious
injury.
Caution indicates a
potentially
hazardous situation which, if not
avoided, may result in minor or moderate
injury.
!
CAUTION
!
WARNING
!
DANGER
Notice indicates
important
information, that if not followed, may
cause damage to equipment.
CALIFORNIA PROPOSITION 65
You
can
create dust when you cut,
sand, drill or grind
materials such as wood,
paint, metal, concrete, cement, or other
masonry. This dust often contains
chemicals known to cause cancer, birth
defects, or other reproductive harm.
Wear protective gear.
This product or its
power cord contains chemicals known
to the State of California to cause
cancer and birth defects or other
reproductive harm. Wash hands after
handling.
The following safety precautions must be
followed at all times along with any
other existing safety rules.
!
WARNING
!
DANGER
NOTICE
1. Read all manuals included
with this product
carefully. Be thoroughly
familiar with the controls
and the proper use of the
equipment.
2. Only persons well acquainted with
these rules of safe operation should
be allowed to use the tool.
Safety
glasses and ear protection
must be worn during
operation.
3. Do not wear loose fitting clothing,
scarves, or neck ties in work area.
!
WARNING
MANUAL
REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.
Specifications
Tool
Voltage 120 V, 60 Hz
Chuck Size 1/2"
Max Bit Size 1/2"
Blows per Minute 42,000
RPM 0 - 2800
Power Rating 6 Amps