Campbell Hausfeld JB3495 Nail Gun User Manual


 
6. Remove
nailer from
work
surface. The
Work
Contact
Element
(WCE) must
return to its
original
down position. Pull the trigger. The
nailer MUST NOT OPERATE. Do not
use the tool if it operates while
lifted from the work surface.
Personal injury may result.
7. Pull the trigger and depress the
work contact element (WCE) against
the work surface. The nailer MUST
OPERATE when in bump mode. The
nailer MUST NOT OPERATE if in
sequential mode.
8. Depress the Work Contact Element
(WCE) against work surface. Pull the
trigger. The nailer MUST OPERATE.
LOADING THE NAILER
1. Always
connect
the tool to
the air
supply
before
loading
fasteners.
2. Pull nail
pusher
mechanism
back until
pusher
engages
with
magazine latch.
3. Load strips of fasteners into the
magazine slot. Make sure that the
nails are placed into tool at the
proper orientation.
4. Squeeze
the pusher
and the
latch
together to
unlatch
pusher.
Make sure the head of the last nail is
under the head of the pusher.
UNLOADING THE NAILER
1. Always unload all fasteners before
removing tool from service.
Unloading is the reverse of loading,
except always disconnect the air
hose before unloading.
2. Pull nail
pusher
mechanism
back until
pusher
engages
with
magazine
latch.
3. Hold tool
upright so
nails will
slide
backwards
toward
magazine
slot.
4. Squeeze
the pusher
and latch
together to
unlatch the
pusher
once all
nails have
been removed.
ADJUSTING THE NAIL PENETRATION
The NS219001 and NS349001 nailers are
equipped with an adjustable depth of drive
feature. This allows the user to determine
how deep a fastener will be driven into the
work surface.
1. Adjust the operating pressure to a
pressure which will consistently
drive the fasteners. Do not exceed
the maximum operating pressure of
the nailer of 120 psi.
2. To adjust the depth-of-drive, loosen
the 4mm bolt on the top of nose. To
increase depth, push WCE in toward
nose as much as desired. Re-tighten
bolt. To decrease depth, pull WCE
out as much as desired. Re-tighten
bolt.
3. Make sure that the trigger and work
contact element (WCE) move freely
up and down without binding or
sticking after each adjustment.
ANTI-DRY FIRE
These tools are equipped with an Anti-Dry
Fire feature. This prevents the WCE from
being pushed in when only a few nails
remain. Simply load new nail clip behind
remaining nails to continue shooting.
ADJUSTING THE DIRECTION OF THE
EXHAUST
The nailers are
equipped with
an adjustable
direction
exhaust
deflector. This
is intended to
allow the user to change the direction
of the exhaust. Simply twist the
deflector to any direction desired.
CLEARING A JAM FROM THE NAILER
1. Disconnect
nailer from
air supply.
Model JB3495
5
Rotate
Nail pusher
mechanism
Latch
Nail pusher
mechanism
Latch
1
2
1
2
www.chpower.com