Filter
Top Products
Power Switch
Pressure
Control
Knob
Outlet
Valve
Prime/
Spray
Control
Suction
Filter
Suction
Tube
Bypass
Tube
Bypass
Tube Clip
6
Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Preparation
Airless painting systems, unlike most
other power tools, require additional
care to ensure proper working order.
Following these instructions will
significantly increase the likelihood
of having a positive paint experience.
It is important that the painting
equipment is flush/tested EACH
time a new job is started. Each
pump is tested at the factory with a
fluid that must be flushed from the
system prior to painting. It is also
required prior to each successive use
to flush the storage lubricant from the
system. Flush the system with either
water or mineral spirits. Use water if
spraying water based coatings or use
mineral spirits if spraying oil based
coatings.
Pump Assembly
Assembly Instructions
TOOLS REQUIRED:
u 3/4 in. or Adjustable Wrench
u 5/8 in. or Adjustable Wrench
ASSEMBLY
1. Open packaging and check contents.
2. Remove the equipment and all parts
from the carton.
3. Attach high pressure hose to pump
and spray gun using a 3/4 inch
wrench (See Figure Below).
FIgure - Attach hose
www.chpower.com