Filter
Top Products
Airless Paint Sprayers
7
Operating Instructions and Assembly Instructions
www.chpower.com
Turn Pressure
to HIGH
(completely clockwise)
4
Starting Instructions
While Pulling Trigger,
Direct Fluid Stream Along
Inside of Bucket
7
Power Switch
Location
3
Tip in
CLEANING
Position
6
5
Turn Prime/ Spray
Control
to SPRAY
(knob is horizontal)
Preparation (Continued)
1. Place both suction and bypass tubes
in cleaning solvent.
2. Turn prime/spray control to the
PRIME position.
3. Turn power switch to the ON
position.
4. Turn pressure to HIGH (completely
clockwise). In a few seconds,
cleaning solvent will begin to move
up through the tube. Allow the fluid
to circulate for one minute to ensure
all air has been exhausted from the
pump.
5. Turn prime/spray control to SPRAY
position. Watch for any fluid leaks
(See Troubleshooting Chart if leaks
occur).
NOTE: If unit is building pressure
properly the pump should turn off,
which indicates it has reached its user
set pressure.
6. When flushing the system with
cleansing fluid (either prior to
use with paint or during cleaning
process) the spray tip can remain in
the CLEAN position.
7. Point spray gun into an empty waste
bucket and pull trigger. To reduce
splashing, direct the fluid stream
along the inside of the bucket wall
and well above the fluid level.
1
Place Suction Tube
and Bypass Tube in
Solvent
Turn Prime/ Spray
Control
to PRIME
(knob is vertical)
2