Filter
Top Products
Setup
Followspot 1200 User Manual Rev. 5 -6-
3. Setup
AC Power
The Followspot 1200 has two AC input voltage settings, 208 and 230 VAC, and two AC
frequency settings, 50 and 60 Hz. The voltage and frequency settings require changing
the connections on the corresponding terminal strip. See the
Voltage and Frequency
Selection section in this chapter.
Always connect the Followspot 1200 to a protected circuit with an appropriate
electrical ground to avoid the risk of electrocution or fire.
Power Requirements
To determine the power requirements for the Followspot 1200
see the label affixed to
the fixture. Alternatively, you may refer to the specifications chart in the Technical
Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation.
Please refer to the Sizing the Circuit Breakers section in the Appendix chapter of this
manual.
Power Cord
The fixture side of the Followspot 1200’s power cord enters the control panel through a
strain relief boot. This side of the power cord is hard-wired to the fixture. Therefore,
there is no removable power connector on the control panel.
The outlet side of the power cord is bare-ended. This way, the users will be able to
equip it with the power plug that best matches the local standards and regulations.
Power Cord Pin Out
Connection
Wire (U.S.)
Wire (Europe)
IP-66 Pin
Screw Color
AC Live
Black Brown 1 Yellow or Brass
AC Neutral
White Blue 2
Silver
AC Ground Green/Yellow Green/Yellow 3 Green
Never connect the Followspot 1200 to a rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Fuse Replacement
1) With a Philips screwdriver, unscrew the fuse holder out of its housing and remove
the blown fuse from its holder.
2) Replace the blown fuse with a fuse of the exact same type and rating.
3) Replace the fuse holder in its place, and reconnect power.
Make sure to disconnect the fixture’s power cord before replacing a blown fuse,
and always replace it with a fuse of the same type and rating.
Fuse Holder Diagram
Illuminated
On/off Switch
Fuse Holder
Power Cord
Rubber Boot