Filter
Top Products
MotionDrape™ LED User Manual (Rev. 05) Page 9 of 13
Configuration
(Standalone)
Set this product in one of the standalone modes to control it without a DMX controller.
1. Connect this product to a suitable power outlet.
2. Turn this product on.
Never connect a product that is operating in any standalone mode, whether Static,
Automatic, or Sound to a DMX string connected to a DMX controller. This is
because product
s in standalone mode may transmit DMX signals that could
interfere with the DMX signals from the controller.
Sound Active
Mode
To enable the Sound Active mode, do the following:
1. Press <MENU> repeatedly until Sound shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Yes.
4. Press <ENTER>.
5. Turn the music on until the product responds to the beat of the music.
The product will only respond to low frequencies of the music (bass and drums).
Automatic Mode
To enable the Automatic Mode, follow the instructions below:
1. Press <MENU> repeatedly until Automatic shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Yes.
4. Press <ENTER>.